Remote holder for Koda ceiling light

I got this Koda brand remote controlled ceiling fixture from Costco to put in a closet. Made this box to hold the remote on the wall below the light switch.

It fits perfectly, has some chamfers so it slides in easily, front side is angled open so the bottom fits snug and the top has just a bit of clearance, and leaves the top of the remote exposed so you can press the most frequently used buttons without having to take it out.

I used some 3M removable Command Strips to hold it to the wall without leaving marks.

Print instructions

Category: Organization Print Settings

Printer Brand: Prusa

Printer: i3 MK3

Rafts: No

Supports: No

Resolution: .3 (variable)

Infill: 20%

Filament: Inland PLA White
Notes:

I had it on .3mm layer height but used the Layer editor to "add detail" (decrease layer height) at the top of the arched overhang and the chamfer at the very top. I also had a .6mm nozzle on my Prusa so the print time was only 2hr 20min. The chunky walls and 20% infill are both way overkill so this feels incredibly sturdy.