Toothbrush Cover Oral-B Electrical Brush

I've tried a few toothbrush covers on Thingiverse for my Oral-B CrossAction travel toothbrush but they were either unnecessarily complicated two piece models that seemed prone to break easily or didn't fit well, until I hit on wildcardfox's design.

It did fit my brush nicely as it was but also seemed taller than needed, to I trimmed it down a bit in Meshmixer. In a quart sized travel bag, any tenth of an inch counts!

UPDATE 7/21/21: Same functionality, just some cosmetic changes to round the edges.

Print instructions

Supports: Yes

Resolution: 0.2

Infill: 30%

Filament: Hatchbox PETG

Notes:

I printed it both ways, with the open side facing up or facing the bed. Either way you'll need supports. I kind of liked it better with the open side facing up.

If you like what I'm doing…

 … consider buying me a coffee or joining my Club.