Prusa MK3S and MK3S+ Fan Duct with PINDA Support

Searching for a better fan duct, i found this this (thx to xander1)

https://www.thingiverse.com/thing:4124587

The initial tests weren't bad, but the airflow didn't fully reach the rear of the model.

So I copied the design and gave it a bit more length and air baffles to get more air behind the model. Thicker walls give the part a little more strength against the heat.

In addition, I added another holding element for the original fan bracket (Prusa R4 / R5 / R6 Part).

Since the PINDA holder tends to lower itself at high printing temperatures, I added a reinforced notch to support the probe.

My parts are printed from Prusament PC Carbon Fiber to withstand higher temperatures. It prints great !

I think the ASA is sufficient for normal prints with PETG and PLA.

It is best to print 3 or 4 perimeters, much infill ~50% and supports at the air outlets as shown in the picture (no supports for PC Carbon Fiber needed ! )

The fan mount could be print with PETG.

You need:
1x M3 Squarenut (use the existing one)
1x M3x8mm
1x M3 Nut (use the existing one)

FLOWSPLITTER Version added >> Flowsplitter: https://www.prusaprinters.org/prints/124051-print-fan-flowsplitter-mk3-mk3s-mk3s-and-many-othe

Update 04.03.2021
added a MK3S+ Version

Update 18.08.2021
renamed the MK3S+ file and updated the file to the latest Iteration (only small changes for PC  Carbon Fiber printing).

Update 11.01.2022
new lower version added 1.5mm deeper with or without silicon sock.
some new pictures PC Carbon Fiber Parts after 6 month of many printing.
the mk3s+ (R6) parts works on mk3s (R5) too ! 

Update 22.01.2022
renamed Files the “+” will be removed in downloadable zip files O_o
added a lowered 0.5mm and 1.0mm Version 
the mk3s+ (R6) parts works on mk3s (R5) too ! 

Update 31.01.2022
FlowSplitter version added - Flowsplitter ? See Link in Description

Update 21.04.2023
added a 2.5 Version

Print instructions

Print in PC or ASA with supports shown in the picture OR in Prusament PC Blend Carbon Fiber Black without supports and crazy good quality - see the new pictures !

Much infill ~50% and 3 or more Perimeter to make the duct more Heatstable.