Housing for AKKtek A3 3 in 1 camera module

The All-in-One camera module from akktek.com is just an electronics module without any housing and support for attaching to a r/c model.

Although it could be attached by using just some double-sided tape, this would not be robust and reliable enough for various types of applications.

I am using the module on r/c boats, therefore I have coated the electronics with rubber spray to make it somewhat water-resistent.

My housing allows easy attachment by either double-sided duct tape or velcro while not blocking the air flow through the module as is required for cooling.

There are four versions, a very lightweighted housing to be used e.g. for small Tinywhoop copters and three more robust versions if weight and size does no matter that much.

Print Settings

Printer:

Anycubic I3 Mega

Supports:

Yes

Resolution:

0.1 or 0.2 mm