3.7 Gram Dual Micro Servo Mount

This is a very lightweight servo mount for dual 3.7 gram micro servos. These are fairly generic servos and anything listed as "3.7g" should fit.

These are a snap fit but shown is 1/4" #2 screws holding them in. The mount is meant to be glued or screwed down in the fuselage and is an easy way to mount rudder and elevator servos in a small airframe.

The mount weighs under 1.5 grams when printed correctly. See setup below.

Print Settings

Printer:

ANET A-8

Rafts:

No

Supports:

No

Resolution:

.2mm

Infill:

None

Notes:

Use two walls, zero infill, 2 layers bottom, 3 layers top for lightest weight.