BTWIN light GoPro mount / Soporte GoPro para luz BTWIN (NEW w/ offset V2!!)

[EN] It's a mount for a BTWIN light. It's supposed to go mounted on the handlebar, but on a road bike it's difficult sometimes, so i made a mount that can be attached to any GoPro hook, for example under the GPS mount of the bike ( the red attachment of the photos can be bought for 4-5$ on Aliexpress). The light is 45mm wide.

Here you have the Fusion360 files:

• With offset (V2!)
• Without offset

The project is a WIP because the version with the offset has not been tested yet. I did the simple version (without offset) 2 months ago and it has survived since then, but looked quite ugly, so i have done the second version with offset which is, in my opinion, much more stealthy.

[ES] Es un soporte para una luz BTWIN del Decathlon. Se supone que debe ir montado en el manillar, pero en una bicicleta de carretera a veces es difícil ponerlas, así que hice un soporte que se puede unir a cualquier gancho GoPro, por ejemplo, debajo del soporte GPS de la bicicleta (el accesorio rojo de las fotos puede ser comprado por ~4€ en Aliexpress). La luz es de 45mm de ancho.

Aquí tienes los archivos de Fusion360:

• Con retroceso
• Sin retroceso

El proyecto es un trabajo en proceso porque la versión con el retroceso aún no se ha probado. Hice la versión simple (sin retroceso) hace 2 meses y ha sobrevivido desde entonces, pero tenía un aspecto bastante feo, así que hice la segunda versión con retroceso que, en mi opinión, es mucho más disimulada.

Print Settings

Printer Brand:

Creality

Printer:

CR-10S

Rafts:

Yes

Supports:

Yes

Resolution:

0.2mm

Infill:

50%

Filament: HatchBox PLA Grey/Silver

Notes:

• Rafts are not totally necessary, but I had problems with the supports. Using a Brim is recommended
Using low resolution is not necessary but the details are better, i have printed mine with 0.2mm and it's great. 50% infill is recommended. 4 outer layers are recommended. In CURA the "Layer view" should look like this (the one bellow is the version with offset, but it's the same for both versions):