Compound Pulley Wheel

I designed this pulley wheel for a cosplay prop, so I don't know, if it would be suitable for real use (I doubt it, since it is printed in two parts).

It's based on the bow Arrow uses in season 5 of the show.

For one wheel you need to print both files. I split the wheel in half to make it easier to print.

The middle hole is scaled, so that a 4mm rod can fit into it and the wheel is able to spin.

After printing, just glue the two pieces together and make sure the holes are aligned properly.

Print instructions

Category: Costume Print Settings

Printer: Creality CR10
Rafts: Yes
Supports: No
Resolution: 0,12
Infill: 15%