Raspberry Pi + 5 Inch Screen Case (RetroPie Console)

This is a case for my portable RetroPie console. It's for a Raspberry Pi 3B+ and a OSOYOO 5 inch DSI screen.

Feel free to modify the Fusion 360 Model for your needs.

Detailed Description

A detailed description on the setup, the used software and history of the project in my blogpost: RetroPie Revision 2

Hardware

Below is a list of hardware components used in this project. The links go to AliExpress, but you may also find them at Amazon, eBay or your preferred hardware dealer.

• Raspberry Pi 3B+
• 5 Inch DSI Touch Screen
• Speaker 50mm 8 Ohm 2W
• 30x30 5V Fan
• 2mm LEDs
• short HDMI Cable
• i2s Audio DAC breakout
• Micro push buttons
• 2N2222 Transistor
• Resistors
• 8BitDo Zero

Print instructions

Printer Brand: Prusa
Printer: i3 MK3
Rafts: Yes
Supports: No
Resolution: 0.2mm
Infill: 15%
Filament: DasFilament PLA Metallic Red

You want to print with a brim to avoid any warping at the corners. I printed the base using "Octagram Spiral" as the bottom layer pattern to make it a little more interesting to look at.

Be sure to flip the lid by 180 degrees before printing. No supports needed.