TS80 Full Set Case

I decided to make one because others doesn't suit my liking. I also wanted to house 'everything' in this single case without leaving out something else, while I don't have a soldering iron holder, I decided to incorporate into this as well.

• Store 2 tips at once
• Meant to house everything a ts80 need
• Stand/holder to put the ts80 safely during operation

Included 2 stands file, if the stand slab is loose from the divider, print the tighter version, it is meant to be snug fit with the divider. Spool are meant to be glued together then wind solder lead. Use any 1.75mm filament to hold between top and bottom case together. I suggest do a test print of top case first and try the clearance. Sand a little if it is too tight, put something if it is too loose.