Yeti Blue Microphone Shock Mount

A project I undertook when the Covid-19 pandemic hit us and with the move to work from home, I needed a good microphone setup for all the Zoom and Teams meetings I was constantly attending. At the time shockmounts were in demand and supply was limited to none, hence my version of the shockmount.

In addition to all the printed parts in the quantity indicated, you will need seven (7) hair bands, fourteen (14) M3x20 flat head screws, four (4) M3x8 flat head screws, and two (2) M3x16 socket head screws.

There are two options to mount the shockmount in two orientations. The two ring adapters allow the mount to be at 90° from a vertical mic boom, or the straight adapter connected to a tripod. If used on a tripod, then the 58 adapter is required to mate the ring adapter to the tripod ¼"-20 thread.

Print with PLA, PETG, or ABS, 0.40mm nozzle, 2 perimeters, and various layer heights and infill. These were my settings, but if I were to print this again today, I would be inclined to go with 3 perimeters, 20% to 30% Grid infill, and 0.15mm layer height for nice curves and lines.