CREASEE Adapter for Filament sensor with BMG Extruder on Creasee CS30

You can not use the stock filament sensor very well with a BMG Clone extruder on the Creasee CS30. The filament sensor sits about 16mm below the path of the filament in the BMG and it would be a nasty bend in the filament.

This is a simple block to raise the height of the filament sensor. You need 2 M3x35mm screws to mount the sensor and the block. If you do not have these screws, you can you small zip ties to secure thru the screw holes.

On the Z bracket, there are 3 sets of screw holes. The best way to mount this is in the center set of screw holes as that is closest to the BMG filament path.

Happy Printing!!

PLA 200/60 easy print settings not critical.