ARTILLERY GENIUS DRAG CHAIN 20X10MM

Drag chain holders for the Artillery Genius printer.

Drag chain:
UK: https://www.amazon.co.uk/YOTINO-Plastic-Towline-Printer-Carrier/dp/B07S6LW7BK
DE: https://www.amazon.de/YOTINO-Schleppkette-Kabelführung-Kabelschleppkette-Energiekette/dp/B07S6LW7BK

UPDATE:
I drilled a hole into the case so the cables don´t kink as in V1. I highly suggest using the FLAT case mount!

You need to extend the bed-cables. Make sure to do it right, these cables carry 230/110V! If you don´t have the knowledge DON´T DO THIS PROJECT. I´m not responsible for any damage if you do it wrong.

Remove all bed-cables from the PSU and mainboard. Make sure to follow safety guildlines when working on main-power parts.

Install the cableholder onto the bed. Unscrew both back bed screws and slide it on, shouldn´t cause any problems. Put the bed-screws back after you installed it.

Guide the cables through the chain.

You need to drill one hole (3.2mm or slightly bigger) into the metal case. Use the printed part as a guide and make sure you drill the hole even with the one from the power plug. You need two M3x16mm or longer screws, 3 washers and one nut.
Install the case mount, can´t mess up the direction as there is a cutout for the plug.

Test-fit the cables and extend them as much as you need, better to leave them 5cm longer than too short!

Reconnect all cables, plug the chain together and you should be done.

I used 18 chain links to make sure the radius is big enough. The chain sags by design to prevent strain on the connector, it will lie on the table.

Fits on my printer that i bought July 2020. Maybe doesnt fit all printers and i can´t test it.