Ender 3 TFT35 USB Cover

The USB on the TFT E3 is a bit fragile, and if you were to accidentally bump your USB stick while its inserted (like I did) it will probably come loose or break off. I designed this to hold the USB in place if you cant reattach it any other way. Unsure why the Thingiviw will not generate

CAUTION: Tolerances are very tight. Be very careful. I've updated a newer version that should be a bit more lose around the edges of the USB and SD slot, but haven't tested it. Clip/sand down the corners if needed

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

Yes

Resolution:

.2

Infill:

15%-25%

Notes:

Probably doesn't need supports, but it's so small there really is no harm in tossing them. only about 30 minutes at 60mm/s