Revo Nozzle Holder for 2020 Extrusions

So you built a Voron printer and it barely fits in your room and you have no additional space on your table to hold your extra Revo nozzles? Just slap this inside your print chamber at the back or on the sides and now you're all ready to start contemplating what other upgrade you'll spend too much money on. Oooh… Titanium backers! Shiny!

Print using the typical Voron print settings:

• Designed to be printed in ABS
• 0.2 mm layer height
• 0.4 mm line width
• 40% infill
• 4 perimeters
• 5 top and bottom layers
• No supports are required in the default orientation

Additional hardware:

• 2x M3x8 BHCS
• 2x M3 roll-in t-nuts or hammerhead nuts