[HW-132 Case] - USB Step Up Power Supply Module / Voltage Regulator

Two versions are available: with and without screws. The body is made up of two halves, which hold together quite well due to friction - using the screws is recommended, though. Screws required:

2× M2 hex 6 mm (or a bit shorter) (front - near the USB)
2× M2 hex 8 mm (or a bit shorter) (back - near the output)

In case you don't have these screws, print the screwless version! The original product can be purchased here:

DC DC 5V to 3.5V / 12V USB Step UP / Down Power Supply Module Adjustable Boost Buck Converter Out DC 1.2V 24V|Integrated Circuits| - AliExpress

Following settings were used to print this file:

Original Prusa MK1
PETG white prusament
0.2 layer height
30-60% speed
240°C/90°C
No supports
No special settings
Note: One of the pieces needs to be rotated 180° to lie on the flat side

If you find this print useful, please share your results with me :)