Dishcloth hanger with magnet slot

Dishcloth hanger which attaches inside of kitchen sink with magnets. Cloth can then dry out freely and keeps rest of the kitchen table dry and clean.

Magnets which I use are these (15mm x 15mm x 5mm): http://www.ebay.com/itm/181677927583

But you can also customize openscad design and use different size of magnets. Those magnets are really strong and keep cloth easily in place when its wet.

Instructions

1. Print 1 x arm -piece and 2 x base pieces. (I printed my hanger with 10% infill and it is strong enough. If you customize then hanger boom and make it longer then I highly recommended you to print at least 20% infill)
2. Insert 4 magnets 15mm x 15mm x 5mm inside a slot
3. Insert arm in place and make sure it moves freely
4. Acetone weld or glue base -parts together, move arm peace back and forth until glue or acetone dry out.
5. put 4 magnets other side of kitchen sink and place assembled dishcloth hanger inside of sink at the same place where magnets are in the other side.