Small Cable Holder / Clip - under the table

A very quick and simple design of cable holder / clip to be used under the desk or work surface. Due to small dimensions, it is to be used with thinner wires like a mouse, keyboard, headset etc.

Printed on MK3S+, with PLA in 0.3mm draft settings.
Position model flat on the side, no supports needed. 

Available files:

STL 

 “Cable_Clip_screw.stl” - STL to be used when fixing the clip with screw to the surface.
 “Cable_Clip_nail.stl” -   STL to be used when fixing the clip with nail to the surface.
 “Cable_Clip_no_hole.stl” -   STL to be used when fixing the clip with glue/tape etc. to the surface.

Gcode 
“cable_clip_nail_0.3mm_PLA_MK3S_8m.gcode” - ready to print nail version
“cable_clip_screw_0.3mm_PLA_MK3S_8m.gcode” - ready to print screw version
“cable_clip_no hole_0.3mm_PLA_MK3S_8m.gcode” - ready to print no hole version

If you need more of them, don't print 1 by 1 as that is the slowest option.
Use STL to align more as each additional takes only 4 more minutes instead of standard 8.

Average print times:
1clip - 8min, 2clips - 9min, 3clips - 13min, 4 clips - 17min, 5 clips - 21min