Poké Ball Fidget Spinner Button

Alternative version of my Poké Ball Button (https://www.prusaprinters.org/prints/123575-poke-ball-button) which now spins! 

Update (Jan 28, 2022)

Very minor update to solve unnecessary printing parts in gcode.

Files

• Poke Ball Base White Spinner.stl - Base part of Poké Ball with center cylinder print in place. 0.25mm clearance which worked well in Prusa MK3S+ in 0.1mm layer with .4mm nozzle.
• Poke Ball Top Red Spinner.stl - Top part of Poké Ball. Standard color is red, use your preferred color for this as you like. Recommended to print in 0.1mm layer.
• Poke Ball Line Right Black Spinner.stl - Right side of the line.
• Poke Ball Line Left Black Spinner.stl - Left side of the line.
• Poke Ball Front Ring Black Spinner.stl - Front ring line part

Print

See gcode files. My recommendation is to use 0.1mm layer height for the spinning base part and top part. Line files are fine with 0.2mm layer height.

Notes

Depending on the printer and the filament, male connector with 35 degrees angle upwards in 1mm thickness may be little challenging. Please use your knife to clean if you see some issue with the upward angle, then it should fit nicely.