Enclosure for RMHV2.1 - DDCSV2.1 - RMHV3.1 - DDCSV3.1 - CNC Router Controller

I designed this enclosure to mount it to my MechaPlus ProBasic 06-05 CNC Router. But it can be used for any CNC Machine. I deliberately left out the Stepper drivers which are in a separate enclosure that came with the machine. It is connected via a male-male DB25 cable (was used with the LPT port back in 2009 when I bought the machine. 

You need 

• IEC connector Snap In IEC C8 PLUG PANEL PLUG 250 V/2 A
• Rocker switch Snap In for hole size 12,7mm x 20mm
• DB25 Female (to CNC machine)
• DB15 Female (to MPG)
• 3.5mm Jack Socket (to tool probe)
• 3 x 28mm x 100mm aluminum tube (1mm to 2.5mm wall thickness). I added plastic replacements to print. Not sure if they last.
• LED power supply 24V/30W. I found one on Amazon that is really small (92 x 42 x 20mm). 
• 14  M2.5 x 6 countersunk screws black. 

The enclosure can be used as a desktop device (only use “Enclosure Main” and “Enclosure Bottom” parts) or with the arm that can be attached with 4 x M6 screws to the frame of the machine.

Printing

I deliberately used 5-6 perimeters to avoid infill in the 3mm walls. This not only makes prints faster but also stronger.  I also increased the solid layers to avoid infill in the 3mm walls. 

Main enclosure: The main enclosure is printed upside-down to avoid a lot of support. The print came out well in speed mode. I expected to reprint it as usual (things may not work) but besides the 8mm hole for the tool-probe connector all was good. 

Mount Tube Replacements: In case you don't have a 28mm aluminum tube these parts can be printed. I have not checked the tolerances. I highly recommend using aluminum tubes.

I also included the G-code files. I highly recommend re-scicing the 3mf files once you start to incorporate latest settings. I used Prusament Galaxy Black and Galaxy Silver PLA Filament.