Nerf Longshot Muzzle Brake

This is a barrel shroud and muzzle brake for a Nerf blaster, specifically the Longshot main gun.
The shroud is designed to fit around a 318mm long, 16mm OD barrel (worker longshot kit) and inside the front locking lug of the blaster. The muzzle brake fits around the shoud as well as the barrel and is held in place with 2x M4x12 bolts or 2x M4x16 bolts and nuts lock from the back.

There are two versions of the muzzle brake:

• Smooth is just an extension of the shroud with a 16mm inner diameter.

• Scar has an integrated scar-barrel designed by somebody who has no actual idea of what he' s doing. Use at your own discretion The muzzle brake itself has no function, since nerf guns don't have flash or recoil to compensate. It just looks cooler than the flat end of the naked blaster.

  The front end of the blaster in the photo is wurstwerfer's frontend, which is a nice completion for the whole look.

  This frontend could be used on pretty much any blaster with a front locking lug or a 16mm barrel sticking out the front, but on some blasters it might look somewhat ridiculous

  Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

No

Supports:

Yes

0,2mm

Infill:

15%

Notes:

I had best results printing the muzzle brake and the locking ring upside down with full supports except inside the scar-barrel.
The Barrel-shroud prints best right-side up with supports only on the build plate, or upside down without supports if you trust your printer enough