Table Saw / Miter Slot T-Nut

If you find this useful, please consider sending a tip. Thanks!
https://paypal.me/cdsmakestuff

Miter Slot T-Nut for Table Saw or other tool with similar "T" slots

These are probably (most likely) going to fail if you tighten them toooo much.
But they should stay in place with minimal torque on the bolt / nut.
I printed them with really thick walls / top and bottom - see printer settings below.

Designed for:
1/4" x 20 Hex Nut or Bolt
3/4" Miter Slot with wider bottom groove

Dimensions of Miter Slot on my Table Saw (Rigid TS3650):
Overall Height: .42"
Upper Slot width: .759"
Lower Slot Width: .95"
Lower Slot Height: .157"

Top of T-Nut sits just shy from the top of the table for clamping / tightening.
T-Nut (as designed in my saw) has very little slop or play but moves freely in slot.
Hex nut or bolt fits very snug... no glue needed.

Print settings are what I hope makes for a fairly strong part

Print Settings

Printer:

TronXY P802E (modified)

Rafts:

No

Yes

Resolution:

medium

50

Notes:

Print with hex side down... I used supports inside hex area to avoid sagging.
Infill is 50% squares w/ 2 lines

6 top and bottom layers

6 perimeters

Glass heated bed / hairspray (still can't believe how great that works!)

Printed in PLA (all I have at the moment)