Ridgid Jobsite Table Saw Miter Bars 1/4" and 3/8" sizes

I liked the edits on the featherboard done by r00nee, but the miter bars didn't fit in my Ridgid table saw miter slots, so I edited in order for them to fit.

While I was at it, I changed the bottom of the bar to hold either 1/4-20 Hex nut or 3/8-20 Hex nut bolts. Just add a dab of glue, insert your bolt, and you're good to go.

If you get elephants foot or first layer squish, you may have a tight fit, so just lightly sand down the sides and it should slide in smoothly.

Update 3/11/21 - Added a sample print if you want to see if these bars will fit with your non-Ridgid table saw miter bars.

Print Settings

Printer Brand:

Creality

Printer:

CR-10

No

Supports:

Yes

.3

Infill:

15