UFS-068 Parts Tray with Funnel & Lid

This part tray lid looked familiar. I was curious about the part. https://www.thingiverse.com/thing:4387454 Months ago, I had printed a similar tray.

The lid was designed to fit this parts tray. https://www.thingiverse.com/thing:3710646

I didn’t like how the corner of the lid extended weirdly over only part of the tray spout/funnel. I thought it should be trimmed off to leave the spout clear for pouring out parts as designed.

The lid designer gave me a challenge to remix his part. So I did. Here are my two versions, and the tray. (I fixed a couple small errors in the tray stl model. Otherwise no changes.)

I may not print this part because the part tray I have is the original version. https://www.thingiverse.com/thing:918864

If anyone prints, let me know if it works ok.

Update: I did a test print the tray and the lid with the missing corner. The two parts look good together. I think it will be usefull the next time I am sorting and dispensing small parts.

The lid is a close fit, but not tight. There is less than 1mm clearance, but enough that the lid easily slides off. The lid may need to be shrunk slightly to give it a tighter fit.