Stand for Soap-Dispenser "Carlo Milano"

Our kitchen plate is very rough and very laborious to clean. So I made this Stand so it doesn't drip onto to kitchen plate.

It's an automatic soap dispenser from the pearl.ch from “Carlo Milano”

https://www.pearl.ch/ch-a-NX5273-5200.shtml?vid=917&wa_id=27&wa_num=115

It fits a bit tight so you can lift it with the soap dispenser.

No special print instruction needed I think.

My Settings:

• PrusaMINI
• Layer Height: 0.25mm
• Infill: Gyroid
• Prusament PLA Jet Black