E3D v6 clone Silicone Cover

This is a silicone cover for the E3D v6 clone from Banggood (
https://bit.ly/3jfFqsQ
).

It might fit for others too, but I did not check that.

Instructions:
Print everything with about 20%-25% infill. You should print the parts with 0.1mm layer height for a smoother finish.

To fill the silicone into the mold I use these needles and a normal syringe
http://bit.ly/3Fx9dtq

Wait about 2 hours till the silicone is dry to clean everything.

BOM:
6x M3 screw (6mm)
https://bit.ly/3izqOcy

E3D v6 Clone Hotend
https://bit.ly/3jfFqsQ

1x 6mm metal pipe

1x silicone (shore 33 up to 450 degree Celsius)
https://goo.gl/yVxw4y