SK-Go MK3S+ Mosquito Fan + BMG-M + BL-Touch + 5015 fan

Used the MK3S+ remixed duct created by WickedTwister to create a mount for SK-Go.

The fan is at an angle and it does not crash on the left side during sensorless homing.

The cooling is pretty good.

Print instructions

Printed in ASA at 0.15mm layer height.
Supports on build plate only.

For assembly start by mounting the 5015 fan on the fan-shroud-support, then slide the fan shroud on the fan-shroud-support slot.

Install the extruder-plate-mount on the extruder plate. Next install the BL-Touch.

Then install the fan-shroud-mount and the fan-shroud on the extruder plate mount.