Tiltable LEDs for ehajos fumetractor (smart solder fume extractor)

I was missing the possibility to tilt the LED light of the fumetractor in a way to get a better light on my parts which I was soldering. So I decided to create a design with a hinge to add this future to the fumetractor.

For links to the shop to get your fumetractor, see down below.

Additional parts:

• 5x M3 nut
• 2x M3 washer & 2x 10mm M3 Screw (used to mount the hinge to the fumetractor)
• 2x 5mm M3 oval head screw (used to mount the LED bar to the hinge)
• 1x 40mm M3 cylinder head screw (used for the hinge)

Note:

• It could be that you have to extend the wires for the LED light by ~2cm.
• Use a 3mm drill to open the holes of partfumetractor_led_hinges_01.stl entirely.

Print instructions

Print Settings

• Infill: 20%
• Support: no
• Perimeters: 3
• Extrusion width: 0.45
• Layer height: 0.2, 1mm top/bottom thickness
• Filament: PETG, ASA, ABS and similar