Raspberry Pi 3B and 5 Inch Display Case

A case for a Raspberry Pi 3B with a 5 inch display.

I made this to be used with Octoprint and OctoDash...

The display and Raspberry Pi just sit in the case and are held in place by the front cover, no screws.

Front cover clips into place by placing the bottom in first and then pushing in the sides and top.

There are air vents on the top and bottom at the front to allow air to flow up through the case.

This is the display that the case is made for: LANDZO 5 Inch Touch Display https://www.amazon.com.au/dp/B07VFFBDY5/ref=cm_sw_em_r_mt_dp_ERDXN0MVPC33S29QK7J8

I made this design quite a while ago, it's not perfect, but it works well enough for me. The way the front clips on could probably be improved.

Designed in Fusion 360.

I have also included the Fusion 360 file in case it helps anyone who wants to remix it etc… It's one of the first things I designed, so the file is probably a little messy…

Links:

OctoPrint: https://octoprint.org/

OctoDash: https://github.com/UnchartedBull/OctoDash

Print instructions

I think I originally printed this using a 0.2mm layer height in PETG.

I think if I printed it again I would try a 0.3mm layer height to make it a bit quicker.

I used PETG because in the past I have had issues with clips snapping in PLA.

Make sure you place the front cover down flat on the build plate.

Print without support.